select Use Specified Connectors from the Connector Selection drop-down list.the SNMP section to Enable SNMP and provide the SNMP community string that has read privileges on the switch.(If leveraging the Brocade SNMP Agent) Scroll-down to:.From the Device Type pull-down list, select Storage (Array, Switch, Library).Enter the IP Address of the Brocade SAN switch to be monitored.Create a new policy or edit an existing one.In TrueSight, configure the monitoring of your Brocade SAN switch:.
![brocade san switch management software brocade san switch management software](https://www.itinstock.com/ekmps/shops/itinstock/images/brocade-6505-dell-88nxw-24-port-16gb-fc-switch-dl-6505-12-8g-0r-12-port-active-66927-p.jpg)
#Brocade san switch management software how to
Refer to the Installation Procedure to know how to install Hardware Sentry KM. Hardware Sentry KM will run on a system (any server, workstation or virtual machine with network access to the Brocade switch) and will be configured to connect to the Brocade switch to monitor it. BMC TrueSight Operations Management installed and properly configured.The system does not need to be part of the SAN. A PATROL Agent installed on a system with a network access to the Brocade SAN switch.You need a fully working BMC TrueSight environment: Setting up Hardware Sentry KM to Monitor a Brocade SAN Switch Additional Pre-requisites You will then have to use the Server Management Console or Web-Start URL to configure the SMI. During the installation process, you will have to select either the SAN+IP installation type and SMI Agent Only. You must download Brocade DCFM or Network Advisor to install the Integrated SMI Agent. This can be done directly on the switch itself by connecting to its Web management interface. SNMP must have been enabled on the Brocade SAN switch. Pre-requisites If Leveraging the SNMP Agent To know which metrics are collected, refer to:
![brocade san switch management software brocade san switch management software](https://ilovemystorage.files.wordpress.com/2012/10/san1.png)
Depending on the instrumentation chosen, the collected metrics will differ. Once properly installed and configured, Hardware Sentry KM constantly monitors your Brocade SAN switch. the Brocade SNMP Agent which is based on the Fiber Alliance Management MIB (fcSwitch-MIB).Solution Brocade SAN Switch Instrumentation
![brocade san switch management software brocade san switch management software](https://1.bp.blogspot.com/-SfZkV7vsc9g/WcfvHrU9yvI/AAAAAAAAAw4/AAPkEkfdAZcct7W4uyVdqRhxxYK78wMggCLcBGAs/s1600/Screen%2BShot%2B2017-09-24%2Bat%2B11.14.36%2BPM.png)
This article applies to Brocade SAN switches as well as to any SAN switch OEM’ed from Brocade.